| How
to disassemble the male slim type Obitsu body |
| Tools
you need:- phillips head screwdriver
- hair
dryer (or something to heat with)
steps:
- Pull apart each part.
-
Opens up trunk.
- Change head attachment parts
|
| |
| 1. Pull apart each part. | |
|
| 2.Open
up the chest and exchange head attachment parts. |
| |
|
|
| 1. The front and back
portions of the chest are assembled without screws. | 2.Push
a slotted screwdriver into the seam along the shoulder and pry apart | 3.
This shows the chest part when opened. You can take the head attachment part off
by hand.
| |
| |
|
| | 4.Remove
the screw in the end of the head attachment part. | 5.
Choose an appropriate attachment piece that comes with the doll set, and attach
it. | | |
| 3.Disassemble trunk and legs |
| |
|
| |
1.Push a slotted screwdriver into the seam anywhere on
the abdominal part and pry apart, just like chest part. | 2.
This shows the abdomen opened. Take the connections for the legs off by hand.
| | |
| |
|
|
| 3 FRemove
two screws in the waist part to separate the legs. | 4.
Pry the center part off with your screwdriver. | 5.
Now you can remove the legs by hand. | |
**When
joints or attached parts are loose, open it up and tighten screws to adjust.
**These vinyl products are disassembled easily after being softened using a hair
dryer or hot water.
***Be careful when you use heat to avoid injury. |
|
