| How
to disassemble the male normal type Obitsu body (same as black
& clear) |
| | Tools
you need:- phillips head screwdriver
- hair
dryer (or something to heat with)
steps:
- Pull apart each part.
-
Opens up trunk.
- Change head attachment parts
|
| |
|
| 1: Pull apart neck,
hands, legs. | | |
| 2: Opens up trunk. |
| |
|
|
| 1.
Unscrew the four screws on the back of the chest part | 2.Push
a slotted screwdriver into the seam and pry apart very carefully. | 3.
This shows the inside after removal of the back. Remove the abdominal part from
it. | |
| |
|
|
| 4.Remove the four
screws in the abdominal back part. | 5. This shows the
inside after taking the abdominal back part away. You can remove the part that
holds the arms and neck by hand. | 6. Remove two screws
in the waist part. | |
| |
|
| 7.Take the leg joints off the waist part.
NOTE: If the legs are too loose, you can tighten this joint. | |
| 3. Opens up legs. |
| |
|
|
| 1.
Remover two screws in the inner thigh. | 2. Separate
the thigh into two pieces by hand. | 3. Take out the
small screw in the knee by hand. | |
| |
|
|
| 4.Pull
the thigh from the calve. | 5.
Remove the screw from the ankle. | 6.
Take the feet off the leg. | |
| |
**When
joints or attached parts are loose, open it up and tighten screws to adjust.
**These vinyl products are disassembled easily after being softened using a hair
dryer or hot water.
***Be careful when you use heat to avoid injury. |
| 7. This shows all the
parts that make up one leg. | |
